|
|
Post by roadster on Sept 4, 2005 20:51:31 GMT -5
Hello learned fellow SR riders - I'm about to remove the flywheel off the on bench engine and was wondering if I'll have to buy the official magneto holding tool or if someone has got an idea on doing without? I've already reasembled the top end and hope I can avoid having to take it apart again. Any help would be greatly appreciated.
|
|
|
|
Post by roadster on Sept 4, 2005 23:47:29 GMT -5
doh! should have put this in the engine mod forum - is it possible to move it Mr moderator?
|
|
|
|
Post by G Man on Sept 5, 2005 2:33:59 GMT -5
Yes, it is possible!. Done.
G Man
|
|
|
|
Post by StewRoss on Sept 6, 2005 2:14:09 GMT -5
Hi mate,
I'd be getting the proper tool. The consequences of possibly damaging the cases is too severe.
The thread inside the flywheel is fairly fine and you should be careful when placing the tool into it. You should also lubricate the thread in the centre of the tool to avoid possibly seizing or galling the thread.
I used to try to 'bodge' the job years ago and I have learnt to get the proper tools in these cases.
SR
|
|
|
|
Post by roadster on Sept 7, 2005 10:49:58 GMT -5
Good advice Stew - I got the official puller but still think it's time for outside assistance!! (Thanks for moving the thread G Man :  |
|
