|
|
Post by rdsrus on Apr 20, 2024 15:47:25 GMT -5
This is a strange one, had turn indicators go out, traced it back to the switch, all the solder joints failed. If by the outside chance anybody has a photo with where the wires attach inside it would be helpful. TIA
|
|
Petes2Wheels
Full Member
Out riding the country roads
Posts: 102
|
Post by Petes2Wheels on Apr 21, 2024 1:14:25 GMT -5
Hi, this is a simple one. Get a wiring diagram for the year model. One wire will be the ground, more than likely the black. Then will be two wires for either side of the switch. Look at your indicators and the wires. If the right indicator has a purple wire, then solder that to the right side of the switch. Same for the left side colour.
If you have traced the wires should know what colours they are. With the solder, just be careful not to join the wires and keep it to a minimum. Good luck
|
|
