|
|
Post by thumptheton on May 24, 2005 22:22:21 GMT -5
How difficult is it to route the header pipe under the engine. Much thanks, Steve
|
|
|
|
Post by markthump on May 12, 2006 12:30:57 GMT -5
There are a few ways to do it. You could buy pre-mandrel bent pieces of pipe, and cut and weld them together as you would like them, or you could call/email Thumper Stuff (I know the fellow is sometimes a bit behind on his emails, and sometimes out of the shop, or on other calls, so this can be a bother) and ask if he has any pipes that route like that (I do). In fact, I have a system from Jemco, bare metal, welds haven't been ground down, muffler comes out behind your foot, then mounts to the standard muffler mount - $240 for Loud street system, or $230 for LOUDER racing system - so loud that it would be banned at tracks with noise rules.
Mark
|
|
